Load & Tension Preview
Preview separates external demand, estimated stripe tension and utilization. Not a FEM/CFD proof.
Analysis Mode Direction
Wind Speed
20m/s
Pressure 0.540 kN/m²
Self-weight —
Material
Allowable · Warp / Weft —
Warp tensileN/5cm
Weft tensileN/5cm
Safety factor×
Database
Internal constraints loaded
Visualization
External load, stripe tension and risk are evaluated separately. Green marks low local value, red marks the highest local value in the selected view.
Low local value → high local value
MinLowMedRaisedHighMax
Max Demand Index —
Relaxed Unroll
Detached unroll preview. Anchors are released by default, edge lengths are constrained, angles remain free, and the ground plane acts as the target surface.
Ready. Run Preview Unroll to release the mesh and relax it flat onto the ground plane.
Drop / settle force9.8
Simulation steps180
Constraint passes18
Length stiffness0.96
Damping0.88
Floor Z0.00 m
Length tolerance1.00 %
Animation time850 ms
OKTol2× TolCritical
Compared edges— OK edges— Warning edges— Critical edges— Median deviation— Avg deviation— Max deviation— Floor nodes— StateIdle
Unroll Statistics
Control panel for relaxed unroll, stripe translation and length stability. Stripe width is read from Label / Unroll → Flat Sheet.
Fabric / stripes
Stripe width— Segment count— Total stripe length— Gross stripe area— Avg segment length— Min / max segment—
Flat geometry
Mesh footprint area— Bounding box— 3D surface area— Area ratio—
Length check
Max deviation— Average deviation— Critical edges— Solver residual—
Nesting preview
Sheets used— Unplaced stripes— Rough waste—
Label / Unroll Export
Segment IDs, production sheets and unroll exports. Geometry export remains in the sidebar.
3D Label Mode
Sort Segments
Label Size
10px
Label Offset
8px
30° · 17° · 0.86×
Spring
Segment Sheet
0 segments
IDLength
Flat Sheet
0 segments
Flat Sheet settings apply to list and nesting views.